







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tremron Roofing: The Homestead Owner’s Guide
Tremron is a Florida paver and hardscape manufacturer, not a roof shingle brand, so when a Homestead homeowner calls us about “Tremron roofing” they usually mean one of two real situations: a Tremron paver surface (a flat roof deck, a courtyard, a carport slab) that has failed, or a roofing underlayment or trim detail loose under a Tremron tile or paver install where no true “Tremron roofing” part exists. Either way, the work is fixable, the installed price for a Tremron-system paver deck repair in Homestead runs $400 to $1,800, and roof deck replacement runs $8,000 to $20,000. Owners typically discover the failure after a summer storm, when a loose paver rocks underfoot and water pools at the same seam where a slow leak has been darkening the ceiling for months. We install and repair Tremron-compatible systems across South Florida, and we don’t pretend Tremron makes a roof shingle, because they don’t.
Key Takeaways
- Tremron makes pavers, not asphalt shingles or roof tiles. If you’re looking for “Tremron roofing,” it is almost certainly a paver roof deck, courtyard, or carport surface.
- Homestead’s limestone-and-sand subgrade and seasonal downpours cause paver flex and joint erosion faster than most of Florida.
- Installed paver deck repair runs $400 to $1,800. Full replacement runs $8,000 to $20,000, priced flat with a written scope before work starts.
- Written price before any work, a signed change order for any scope shift, and the 365-Day Done Right Promise stand behind every job.
Which Tremron Models This Applies To

Tremron is a Florida-based paver manufacturer, and their product lines ship in the standard paver profiles contractors in South Florida install: Olde Towne, Mega Olde Towne, Capri, Capri Plus, the Tremron 3-piece system, and larger-format stone profiles used for roof decks and driveways. If your surface is a Tremron paver system on a flat deck or low-slope roof, the relevant “part” is usually one of three things: a dropped replacement paver of the correct profile, the polymeric joint sand that fills the paver joints (a 6-12 month wear item), or the slip sheet and drainage mat under the paver field.
Identifying the right paver match takes measure, not memory. Pull one failed paver, flip it, and read the model stamp on the underside – Tremron stamps most of their lines. Note the width (3-inch or 4-inch nominal is the key split between the older and newer profiles) and the corner radius, because a 4-inch paver in a 3-inch field looks wrong by the second row. Truck the loose paver to a supplier and match it against the live sample board; dyes in outdoor UV shift over time, so never buy against a photo. On the OEM-vs-aftermarket question: Tremron OEM paver replacement is the right call for color and form matching every time, because third-party pavers that “read close” will always drift in hue within a year in Homestead sun. Filters and drainage membranes are the opposite – a quality aftermarket geotextile from an established manufacturer matches the Tremron spec at lower cost, and we say so in the written quote.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tremron Roofing Is Failing
- Loose or rocking pavers. Bedding sand has washed out from below and the paver is now acting as a fulcrum on the next one over. One loose paver almost always means three or four around it are also compromised.
- Rutting along the same line, season after season. Water is finding a low spot in the deck slab or subgrade and pooling there. Homestead’s heavy summer downpours turn a quarter-inch depression into a rutted paver channel by August.
- Joint sand washing out and disappearing between storms. Either the joints weren’t filled with polymeric sand, or the sand has aged past its service life. Bare joint gaps let water into the bedding layer and pull the whole field apart.
- Efflorescence (white powdery haze) that reappears after rain. Moisture is trapped in the bedding or sub-base and pushing mineral salts up through the paver. A one-time cleaning won’t fix it; the drainage problem has to be addressed.
- Sagging or deflection at a roof-to-wall transition. Algae growth on the underside of a paver deck, or a stain migrating down the wall, means the slip sheet or the paver itself is exposed where it should be covered. This is the water-intrusion warning sign.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For a Tremron paver deck or courtyard repair in Homestead, an honest installed range in early 2026 is $400 to $1,800 for a localized repair (matching pavers, polymeric re-sand, drainage correction) and $8,000 to $20,000 for full removal-and-reinstall of a residential Tremron paver roof deck or courtyard. Repair of a Tremron-based flat roof detail runs $600 to $2,500 when the issue is a slip sheet, membrane, or transition flashing rather than the field pavers. What drives the range:
- Field size. A single-rocking-paver fix is at the low end. Replacing 200 square feet resets the number.
- Pavers matching. Discontinued Tremron colors can push the price up, because the matching load has to be sourced, not pulled from a shelf.
- Sub-surface correction. If the deck slab is cracked or the bedding failed, both have to be repaired before new pavers go down.
Every Rowan written quote breaks out pavers, setting materials, labor, and any sub-base correction line by line, so you can see exactly what drives the number. Nothing is padded, nothing is hidden, and you get a signed change order before any scope change. The 365-Day Done Right Promise covers the labor and installation, printed on the quote, backed by The Haven Standard. Free Second Opinion on any written estimate you bring from another Homestead contractor – we review it against ours, line by line, at no charge.
DIY or Call Us?
Owners can safely check pavers by hand: wiggle-test every field paver (a loose one tells you the story without tools), sweep a bucket of water down the surface and watch where it pools, and check the underside of a roof-deck paver for damp sand at the joint lines after a storm. Those are observation tasks with no risk.
Where DIY goes wrong on a Tremron roof deck is the repair itself. Replacing pavers on a roof deck or low-slope surface means getting on a roof, lifting pavers that are load-bearing, working around the slip sheet and drainage layer without puncturing them, and re-sanding the field properly with the right polymeric product. A punctured slip sheet doesn’t announce itself; it shows up as a leak into the room below three months later, on the one afternoon you’re away. Roof-level work is a fall hazard, and messing up the slip sheet turns a $400 repair into a $2,500 one. That’s the split: check what you can see, call us for the rest. Reach us at (844) 834-4248, and we’ll come look, photograph what we find, and put a written price in your hands before you commit.
FAQs

With correct installation and polymeric joint sand kept fresh, a Tremron paver deck in Homestead lasts 25 to 40 years before full replacement is needed; the paver surface itself ages well, but the bedding layer and joint sand are wear items that should be refreshed every 3 to 5 years. The first few summers are the test: if you see joint sand washing out after a June storm, the install detail needs attention. Call (844) 834-4248 for a free assessment before another wet season hits.
Yes, in the overwhelming majority of cases. A localized rocking, rutting, or joint-sand issue can be repaired for $400 to $1,800 with matching Tremron pavers and a full polymeric re-sand. Full replacement is only warranted when 30 percent or more of the field is loose or the deck slab below is failed. We diagnose which one you’re looking at with a documented photo record, and we tell you honestly which repair you actually need.
A labeled repair runs a single day; a full deck replacement of a typical 200 to 400 square foot residential surface runs 3 to 5 working days, weather permitting. Homestead’s afternoon storm pattern means we usually schedule pavers early in the morning and plan around the rain window rather than fight it, and the written quote states the projected duration before we start.
We match to the model stamp on the underside of a pulled paver and against the live sample board at a Florida supplier, then order the exact profile and dye lot. Tremron lines don’t all stay in continuous production color, so we don’t guess at the match from a photo – we read the stamp and verify against current stock before we put a number on the quote. Rowan is an independent contractor and is not affiliated with Tremron; we source and install Tremron-compatible pavers as one of the many name-brand materials we work with alongside GAF and Owens Corning roofing, KraftMaid cabinets, Cambria and Silestone countertops.
If you have a failed Tremron paver surface in Homestead and a written price in mind, call Rowan Construction Group Homestead at (844) 834-4248 to schedule your free estimate. We’ll come out, photograph the failure, tell you honestly whether it’s a $400 repair or a full replacement, and hand you a flat written price before anyone touches a paver. Background-checked, uniformed crews. Live person answering the phone, day or night. The 365-Day Done Right Promise on every job, backed by The Haven Standard – not a handshake.
Written by the team at Rowan Construction Group Homestead, serving Homestead and nearby areas.












