







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
James Hardie Bathroom Remodeling: The Homestead Owner’s Guide
We install James Hardie bathroom systems for Homestead homeowners, and a full bathroom remodel runs $9,000 – $28,000 installed, with a written flat price before any work starts. Most owners don’t go looking for this product by name. They call us after a wall behind the shower tiles bulges soft, or a painted corner of the bath starts bubbling at the baseboard, or a ceiling stain keeps coming back after the third repaint. In Homestead, that pattern usually points to hardened fiber-cement or gypsum board that took on water long before anyone noticed.
Which James Hardie Models This Applies To

James Hardie makes fiber-cement siding and exterior trim, not a bathroom-wall product line. So on a bathroom job, the material you’re matching is either HardieBacker cement backer board for wet areas or the original fiber-cement cladding on your home’s exterior wall, which matters when a bath remodel touches an exterior wall. We match on three things: thickness, the printed backer stamp, and the installation spec. HardieBacker comes at 1/4-inch and 1/2-inch nominal. Use 1/4-inch only over a solid substrate like plywood or a framed bench top; the 1/2-inch goes on studs at 16 inches on center for walls under tile. The stamp on the face is your label; measure it and photograph it before you order anything.
On the OEM-versus-aftermarket call, fiber-cement backer board is fairly interchangeable as a category but not as a spec. A generic cement board that runs 1/4-inch thinner or accepts water differently than the HardieBacker spec changes how your waterproofing membrane bonds, and that’s where tile jobs fail six years later. We quote the branded board when the scope calls for it. Rowan Construction Group Homestead is an independent contractor and isn’t affiliated with James Hardie. We also source KraftMaid, Cambria, and Silestone for the finish side of a bathroom.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your James Hardie Bathroom Remodeling Is Failing
- Soft or spongy floor near the shower curb. Water gets behind the membrane and saturates the subfloor, not the tile. By the time the tile feels loose, the OSB or plywood underneath has already started to delaminate.
- Crumbling or white-chalky grout lines. Grout that turns powdery is usually efflorescence, gypsum or cement leaching as moisture moves through the wall assembly. In Homestead’s humidity, that moisture rarely dries out on its own.
- A bubbling or stained ceiling on the floor below. A slow leak under a tub or behind the shower pan shows up downstairs first. If you’re seeing a brown ring, the trap or pan liner is already compromised.
- Tile popping off the wall in a single section. Adhesive that fails in one patch usually means the backer wasn’t the right thickness or wasn’t fastened to the stud spec. The tile isn’t the problem; the substrate under it is.
- A hollow sound when you tap the shower wall. A dull thud instead of a dense tap means the backer has separated from the stud or the thin-set never bonded. That’s a tear-out, not a caulk-and-go.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

In Homestead, bathroom remodeling runs $9,000 – $28,000. Smaller baths land at $5,000 – $12,000, a walk-in shower alone is $4,500 – $12,000, and a tub-to-shower conversion is $3,500 – $10,000. A shower replacement is $3,000 – $8,500, and replacing just the vanity is $800 – $3,000.
The range is driven by three things: how much floor and wall assembly has to come out, whether the plumbing moves, and whether you’re going tile or a prefab pan. We separate parts from labor on the quote so you can see what the HardieBacker, the membrane, and the fixtures cost versus the install. Every price is written and flat before work starts, and changes only move forward on a signed change order. The work carries our 365-Day Done Right Promise.
DIY or Call Us?
You can safely check a few things yourself: photograph the printed stamp on the backer board, look for staining on any ceiling below, and tap the shower walls to find hollow spots. What we don’t recommend is tearing into a wet wall or re-grouting a shower you suspect is leaking. Once you break the waterproofing layer, the tile and membrane have to come out and go back in together. A half-done repair lets water travel deeper and drives the eventual cost up. By the time you’re cutting into a failing shower in Homestead, the safer move is a written estimate. Call (844) 834-4248 and we’ll walk the failure with you.
FAQs

How long does a James Hardie bathroom remodel last in Homestead? A correctly installed backer-board and tile system lasts 20 to 30 years; the waterproofing layer is what determines the lifespan, not the tile. In Homestead’s humidity, a badly sealed shower can fail in under 10. Call (844) 834-4248 for an exact quote on your bathroom.
Can the failing material be repaired instead of replaced? Sometimes the vanity or a single fixture can be swapped without a tear-out; a leaking shower wall cannot. If the backer has taken on water, patching it hides the problem. Call (844) 834-4248 and we’ll tell you which you’re looking at.
How long does the project take? A small bath runs 5 to 10 working days; a full remodel with a new shower pan runs 2 to 4 weeks. Schedule is written into the scope. Call (844) 834-4248 for a start date.
How do you source the materials? We quote branded HardieBacker or an equivalent spec board against your existing framing, and finish selections through KraftMaid, Cambria, or Silestone. The part list is on the written quote. Call (844) 834-4248 for a free estimate.
Written by the team at Rowan Construction Group Homestead, serving Homestead and nearby areas.












