







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Delta Home Additions & ADU: The Homestead Owner’s Guide
Delta-compatible home additions and ADUs in Homestead typically run $45,000 – $130,000 for a standard addition and $90,000 – $220,000 for a detached or garage-conversion ADU, quoted as a flat written price before work starts. If you’re landing here because a component of your Delta addition has failed – a support beam showing deflection, a foundation crack widening, a roof tie-in leaking – you’ve found the right page. Homeowners usually notice it one of two ways: a new crack in the drywall seam where the addition meets the original house, or a soft spot in the floor along an exterior wall. Both point to the same small set of causes.
Which Delta Models This Applies To

Delta builds a handful of modular and site-built addition systems, and the component that failed determines the part you need. Identify your system before anything else: check the manufacturer label typically fastened to an interior wall panel near the access point or in the addition’s utility closet, and note the model and series number. Beam spans on Delta additions commonly range from 12 to 24 feet for header assemblies, and joist spacing at 16 or 24 inches on center – a mismatch here is the most common compatibility gotcha we see in Homestead, where a homeowner orders a replacement header sized for a 16-inch layout and finds the original built at 24. For roof tie-ins, match the shingle line and underlayment spec, not just the color.
OEM versus quality aftermarket: for structural members and foundation hardware, OEM or an engineered-equivalent rated to the same load is the safe call, because the addition’s design load depends on it. For cosmetic or finish parts – fascia, trim, flashing – a vetted aftermarket source is fine and often cheaper. We source across more than fifty vetted brands, the same way we handle KraftMaid, Cambria, and Silestone on interior work, and we price the part and the labor on separate lines so you can see both. Rowan Construction Group Homestead is an independent service provider and is not affiliated with Delta.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Delta Home Additions & ADU Is Failing
- Diagonal drywall cracks where the addition meets the house. The two structures are settling at different rates, which points to a footing or beam issue, not a drywall problem. Patching the drywall hides it for a season and it returns.
- A soft or bouncy floor along an exterior wall. Water is reaching the subfloor or a joist is undersized for the span. In Homestead’s summer rain and high water table, this one moves fast once it starts.
- Staining or a drip at the roof tie-in. The flashing where the addition roof meets the main roof has failed or the underlayment spec is wrong. This is the single most common call we get on Delta additions and the cheapest of these issues to catch early.
- A widening crack in the foundation or slab edge. Soil movement or a footing that wasn’t sized for the load. A hairline crack is cosmetic; anything you can slide a coin into needs a look.
- Doors or windows in the addition sticking seasonally. The frame is racking, usually from a header that’s deflecting under load. Intermittent sticking is an early signal worth a free second opinion on any existing written estimate.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s the installed price range for Homestead work, part and labor on separate written lines:
| Scope | Installed Price Range |
|---|---|
| Structural repair to an existing Delta addition (beam, header, footing) | $45,000 – $130,000 |
| Garage conversion to living space | $30,000 – $80,000 |
| ADU construction | $90,000 – $220,000 |
What drives the range: the span and load rating of the structural member, whether the footing needs a redesign, permit and inspection scope, and finishing to match the original house. Under Clause 1 of the Haven Standard, the price is written before anyone starts, and no change proceeds without a signed change order – the discipline that has kept Rowan’s projects within a few percent of the agreed cost across 4,000-plus jobs. The 365-Day Done Right Promise covers the workmanship, and every visit includes a documented photo record at no extra cost.
DIY or Call Us?
Some checks are safe and smart: photograph the crack with a ruler for scale, note whether the floor softness spread, and confirm the manufacturer label model number for the record. What’s not a DIY job is anything structural – a footing, a load-bearing header, or a roof tie-in on a Delta addition. These carry the weight of the whole structure and a wrong repair is dangerous. That’s the honest line, not a sales tactic. Our technicians have up to 19 years of experience, and we’ll tell you plainly what we found and what it means. Call (844) 834-4248 to schedule a free estimate – it’s free and there’s no pressure.
FAQs

How long should a Delta addition last in Homestead? A properly built and maintained addition should serve 40 to 50 years. The catch in Homestead is our climate – heavy summer rain, high humidity, and a shallow water table accelerate roof tie-in and footing wear faster than in drier parts of Florida. Flashing and drainage are the first things to inspect every few years. Call (844) 834-4248 for a free assessment.
Can it be repaired instead of replaced? Often yes. A failed flashing repair is a fraction of a full replacement, and a small footing issue can sometimes be stabilized rather than rebuilt. A structural beam or header that’s deflecting usually needs replacement rather than patching, but a written inspection tells you which. Call (844) 834-4248 for a free second opinion on any written estimate.
How long does the repair or swap take? Cosmetic and flashing repairs are often a day or two; structural work and footings run longer and depend on permit and inspection timelines. We’ll give you a written scope and schedule before anyone picks up a tool. Call (844) 834-4248 for the specifics.
How do you source the part? We match the OEM or an engineered-equivalent rated to the same load, verify against your Delta model number and the measurements on site, and quote the part and labor separately. Call (844) 834-4248 for a written price.
Written by the team at Rowan Construction Group Homestead, serving Homestead and nearby areas.
Ready to get it fixed right? Call (844) 834-4248 for your free estimate. We’ll inspect the addition, put the price in writing, and show you exactly what we found.












