







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Sterling Home Additions & ADU: The Homestead Owner’s Guide
A Sterling-compatible home addition or ADU in Homestead runs $45,000 – $130,000 installed, with detached ADUs at $90,000 – $220,000 and garage conversions at $30,000 – $80,000. Rowan Construction Group Homestead quotes a flat written price before any work begins, and every project is documented with a photo record when the crew leaves. We are an independent contractor and are not affiliated with Sterling.
Owners usually discover a failing addition or ADU the same way: a hairline crack widens along the tie-in where the new wall meets the original block, a door in the new wing starts catching on its frame, or a musty smell shows up in the converted garage after a wet August. In Homestead, that smell is often the first sign the flat roof or the wall assembly is holding water it shouldn’t. Getting a written scope in front of those symptoms early is cheaper than waiting for mold to set in.
Key Takeaways
- An addition in Homestead costs $45,000 – $130,000; a detached ADU runs $90,000 – $220,000.
- A garage conversion is the lowest-cost path at $30,000 – $80,000.
- Homestead’s high water table and hurricane-zone wind loads drive most ADU foundation and tie-down costs.
- Every Rowan project comes with a written price, a written scope, and a photo record.
Which Sterling Models This Applies To

Sterling builds several product lines in this category, and the part you’re matching depends on which one you have. Roof truss connectors, wall panels, and tie-down hardware differ across Sterling’s modular and site-built lines, and Homestead’s High-Velocity Hurricane Zone designation means your connection hardware has to meet a specific uplift rating that varies by product. Before ordering anything, find the model or series label on your structure. On a Sterling modular unit it’s usually on a plate inside the utility closet or on the electrical panel door; on a site-built addition, check the permit packet the building department keeps on file. Measure the tie-in points and photograph them with a tape in frame.
The OEM-versus-aftermarket decision matters here. Sterling’s own connector hardware carries the matching uplift rating and the paperwork a Homestead inspector will want to see. Aftermarket equivalents that carry the same Miami-Dade NOA (Notice of Acceptance) number are usually a fraction of the price and perform identically. What you should not accept is a generic hurricane strap with no NOA on it, because the inspector will reject it and you will pay the labor twice. We source hardware that carries the correct NOA for your structure, and we show you the documentation before we install it.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Sterling Home Additions & ADU Is Failing
- Cracks along the tie-in line between new and original walls. Differential settlement between the new footing and the original slab. In Homestead’s sandy, high-water-table soil, this shows up in the first two rainy seasons if the footing was under-poured.
- Doors and windows in the addition that stick or drag. The frame has shifted, usually from the same settlement or from moisture swelling the wall assembly.
- Musty smell or visible mildew in the new wing. A failed flat-roof membrane or a flashing detail that isn’t shedding water. Homestead’s summer rain intensity exposes weak roof-to-wall details fast.
- Sunlight or drafts at the wall-to-ceiling junction. A gap in the tie-in or failed sealant at the top plate. It lets in water during wind-driven rain and drives up cooling cost year-round.
- Rust streaks on the hurricane straps or connectors. Salt air and humidity have reached galvanized hardware that wasn’t rated for coastal exposure. This is a structural concern, not cosmetic.
Two of these symptoms – moving doors and rusted connectors – point to the structure, not the finish. Those need a professional look before you spend money on paint or trim. The rest are worth documenting and reviewing with a contractor who can read the assembly, not just the surface.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what the work runs in Homestead, as installed price ranges:
| Scope | Installed Price Range |
|---|---|
| Home Addition | $45,000 – $130,000 |
| ADU Construction (detached) | $90,000 – $220,000 |
| Garage Conversion | $30,000 – $80,000 |
| Structural repair / tie-in retrofit | Quoted in writing after inspection |
The range is driven by three things: foundation and tie-down requirements for Homestead’s wind zone, the finish level you choose (impact glazing, flooring, cabinetry), and whether utilities need to be extended or relocated. We quote parts and labor as a flat written price, itemized so you can see what the hardware, membrane, and finish packages each cost. No change proceeds without a signed change order. Every job carries our 365-Day Done Right Promise, and if it’s not done right, we make it right. Structural repair work is quoted after a walk-through because the baseline in a failing assembly is rarely visible until we open it up.
DIY or Call Us?
Some of this you can safely check yourself: photograph the cracks, measure the door gaps, look at the connectors for rust, and note where moisture is showing. Put the model label and the permit packet in one folder so the contractor has the facts. What you should not attempt is opening a wall to inspect framing, patching a roof tie-in, or replacing structural connectors on your own. The connectors hold your addition to the original structure under hurricane wind loads; a wrong strap or a missed fastener is a life-safety failure, not a cosmetic one. That’s the honest line. Call (844) 834-4248 and we’ll come look at it and put a number in writing.
FAQs

How long does a home addition or ADU last in Homestead? A properly built addition lasts 30 – 50 years or more, but the connection hardware and the roof-to-wall flashings are the parts that fail first in Florida’s heat and salt air. Galvanized connectors exposed to coastal humidity can rust through in a decade if the initial coating was marginal. A documented inspection every few years catches it early and keeps the assembly functional.
Can a failing tie-in or roof detail be repaired instead of rebuilt? Often, yes. A localized tie-in failure, a bad connector, or a failed flashing can be repaired without rebuilding the addition. The cost depends on how much of the wall or roof assembly has to be opened to reach it. We’ll tell you honestly whether repair will hold or whether the underlying assembly needs replacement. Call (844) 834-4248 for a free estimate and we’ll put the answer in writing.
How long does a structural repair or replacement take? A connector retrofit or localized flashing repair is typically a few days of work once the parts are on site. Homestead’s permit review can add a couple of weeks to the timeline, and we don’t start the clock until we have the permit. Larger assemblies take longer, and we’ll give you the schedule in the written scope. Call for an estimate and we’ll map it out.
How do you source the Sterling-compatible part? We match the model label to the correct hardware series and order the part that carries the NOA rating your structure requires. We don’t stock parts and we don’t carry them on a truck; we order the exact part and show you the documentation when it arrives. That way you know what went into your structure before we install it. Call (844) 834-4248 to start.
If you’re comparing this against other trades – cabinets and countertops (we also work with KraftMaid, Cambria, and Silestone), roofing, or windows – bring us the written estimate and we’ll review it line by line at no charge through our Free Second Opinion offer. Our technicians have up to 19 years of experience, and every crew member is background-checked and arrives uniformed. You get a live person on the phone 24/7, and you get photos of what we found and what we did.
Call (844) 834-4248 to schedule your free estimate. We’ll bring the written scope, the itemized price, and the documentation you need for the Homestead building department.
Written by the team at Rowan Construction Group Homestead, serving Homestead and nearby areas.












