







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CertainTeed Bathroom Remodeling: The Homestead Owner’s Guide
We install CertainTeed bathroom assemblies and match replacement parts to the exact series, and a full bathroom remodel in Homestead runs $9,000 – $28,000 installed, with smaller baths at $5,000 – $12,000 and single-component swaps like a shower replacement at $3,000 – $8,500. Rowan Construction Group Homestead is an independent contractor, not affiliated with CertainTeed. Most owners discover a failure the same way: a stain blooming on the ceiling below, grout that crumbles under a fingernail, or a shower pan that stays damp two days after the last shower. By then the substrate is usually wet, and the fix is bigger than the part that broke.
Which CertainTeed Models This Applies To

CertainTeed’s bathroom work splits into three buckets, and each takes different parts: glass mat gypsum backer board (DensArmor and DensShield lines), fiber cement siding and trim used in bath venting and exterior transitions, and the tile and membrane accessories that go with them. The board lines run in 1/4-inch, 1/2-inch and 5/8-inch thicknesses with 4×8 and 4×10 sheets; using the wrong thickness behind a shower wall is the most common compatibility miss we see in Homestead.
To identify what you have, look at the printed edge tape on any exposed board (the series name and thickness are stamped there), then measure actual thickness with a caliper, not a tape. If the label is gone, the fasteners tell the story: CertainTeed boards specify coated screws at a set spacing, and a previous installer’s drywall screws are a red flag for the whole assembly.
On OEM versus aftermarket: CertainTeed-branded accessories cost more and guarantee a spec match, while quality aftermarket backer, membranes and sealants are fine when they meet the same ASTM standard. We name the spec on the written quote so you can compare. We source across fifty-plus vetted brands and also work with KraftMaid, Cambria and Silestone when a bath scope crosses into cabinetry or tops.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CertainTeed Bathroom Remodeling Is Failing
- Soft or crumbly board behind tile. Water has reached the gypsum core, usually through a failed sealant joint at the pan or valve trim. Once the core is wet it does not dry out in Homestead’s humidity.
- Grout cracking along a shower wall seam. Movement, not bad grout. The board is flexing because it was installed thin or fastened at the wrong spacing.
- A shower pan that stays damp. The pre-slope or membrane under the pan has failed, so water pools instead of draining. This one always means opening the floor.
- Musty smell that returns after cleaning. Mold is growing on the back side of the board. You are smelling the cavity, not the tile face.
- Ceiling stain below the bathroom. A supply line, drain or pan leak has traveled. Stop using the fixture and get it looked at before the drywall spreads the damage.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For a bath in Homestead, here is where the numbers land, installed, parts and labor together:
| Scope | Installed range |
|---|---|
| Full bathroom remodel | $9,000 – $28,000 |
| Small bathroom remodel | $5,000 – $12,000 |
| Walk-in shower installation | $4,500 – $12,000 |
| Tub-to-shower conversion | $3,500 – $10,000 |
| Shower replacement | $3,000 – $8,500 |
| Bathroom vanity installation | $800 – $3,000 |
The range is driven by how much wet substrate we have to remove, whether the pan and valve survive, and tile choice. You get a flat written price before any work starts, a written scope, and a written warranty, under Clause 1 of the Haven Standard. No change proceeds without a signed change order. Every visit includes a documented photo record of what we found and what we did, and the 365-Day Done Right Promise covers the work.
DIY or Call Us?
You can safely check a few things yourself: press the board at the shower corners with a thumb, look for cracked sealant at the valve and pan, check for a musty smell, and note any ceiling stain below. What you should not do is open a wet wall and try to re-seal over it. The failure is behind the tile, and covering it traps moisture in the cavity, which is how a $3,000 shower replacement turns into a full bath gut in a Homestead summer. There is no high-tension or electrical hazard in this work, but there is a real risk of making a wet assembly look dry while it rots. Call (844) 834-4248 and we will tell you honestly whether you have a repair or a replacement.
FAQs

Properly installed backer board and a sound pan last 20 to 30 years, but in South Florida’s humidity the sealant joints and the pan membrane are what fail first, often at 10 to 15 years. Call (844) 834-4248 for a free estimate if yours is past that mark.
Sometimes, if the damage is confined to one wall and the core is dry. If the pan or the full shower surround is wet, repair just delays the cost; a shower replacement at $3,000 – $8,500 is usually the honest answer. We will show you the photo record so you can decide.
A shower replacement typically runs three to five working days; a full bath remodel runs two to four weeks depending on tile and fixtures. We give you the schedule in writing before we start.
We match by printed series and measured thickness, not by guessing from photos, and we name the spec on the quote. Free second opinion on any written estimate: bring a competitor’s quote and we will review it line by line at no charge.
If your CertainTeed bathroom in Homestead is showing any of these signs, the fastest path to a real number is a call. Reach us at (844) 834-4248 for a free estimate, with a flat written price and a documented photo record on every visit.
Written by the team at Rowan Construction Group Homestead, serving Homestead and nearby areas.












