







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tamko Bathroom Remodeling: The Homestead Owner’s Guide
Tamko doesn’t make bathroom remodeling parts, and that’s the first thing to get straight. Tamko Building Products is a roofing and waterproofing manufacturer, so a “Tamko bathroom remodeling” search almost always traces back to a homeowner who has a Tamko product on the roof or underlayment level and a bathroom moisture problem below it, or to a Tamko underlayment being used as a tile backer in a remodel. If that’s your situation, we install Tamko-compatible bathroom work in Homestead at $9,000 – $28,000 for a full remodel, and we can usually schedule a free estimate within the week.
Owners in Homestead typically discover the problem in one of two ways. Either a bathroom ceiling stain shows up under a Tamko-shingled roof after a summer storm, or a tile floor or shower wall starts moving and cracking because the underlayment underneath wasn’t rated for wet areas. Both point to the same question: what’s actually under there, and what’s the right material at the right layer?
Key Takeaways
- Tamko is a roofing and waterproofing brand, not a bathroom fixture brand. Most “Tamko bathroom” jobs are about what sits above or below the bathroom.
- Full bathroom remodel in Homestead: $9,000 – $28,000. Small bathroom: $5,000 – $12,000.
- We’re an independent contractor. We are not affiliated with Tamko.
- Written flat price and written scope before any work starts, under the Haven Standard. No signed change order, no change.
Which Tamko Models This Applies To

Tamko’s product families split into two groups that matter here. On the roof side you’ll find shingles (Heritage and Titan lines among them), underlayments, and low-slope roll products. On the waterproofing side you’ll find peel-and-stick membranes and flashing tapes. A bathroom under a Tamko roof doesn’t care what brand the shingle is – it cares whether the underlayment and flashing were installed to spec at penetrations like vent stacks and skylights, because that’s where water gets in first in South Florida’s rain load.
Identifying what you have means a label check and a measurement, not a guess. Shingle wrapper labels and underlayment roll ends are printed with the product line and coverage; underlayment is also sold by weight per 100 square feet, which is a spec worth recording. For tile backer, the relevant number is thickness (typically 1/4 inch to 1/2 inch) and whether the board is rated for wet areas or dry only. A peel-and-stick membrane has a printed product name on the release liner. Photograph every label before you throw the wrapper away – it’s the fastest way to match an OEM replacement later.
OEM versus equivalent: for shingles and underlayment, matching the existing product line is usually the safer call because mixing profiles on a visible roof plane looks wrong from the street. For tile backer and membranes, an equivalent product from a reputable manufacturer performs the same job, and the honest conversation is about spec match, not the logo on the board. KraftMaid, Cambria, and Silestone come up once the finish side of the bathroom enters the plan.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tamko Bathroom Remodeling Is Failing
Here’s what failure actually looks like in Homestead homes, and the cause behind each one.
- Ceiling stain directly under the roof plane. Water is reaching the bathroom ceiling from a compromised shingle, a flashing that lifted at a vent boot, or underlayment that was lapped the wrong direction. In Homestead, afternoon storm intensity finds every lap error within a season.
- Tile that sounds hollow when tapped. The thinset didn’t bond, or the backer board wasn’t rated for the wet area it’s in. Hollow tile in a shower or floor is the early warning before a crack or a loose corner.
- Cracked grout lines that keep returning after re-grouting. Movement underneath, usually a substrate that flexes or a backer board that absorbed moisture. Re-grouting a moving floor is patching a symptom, not the cause.
- Soft or swollen baseboard and drywall near the shower or tub. A failed membrane or a gap in the waterproofing behind the tile, letting water track into the wall cavity. It reads as a cosmetic issue and behaves like a structural one.
- Musty smell in a bathroom that vents properly. Ventilation isn’t the problem; moisture is getting in from behind or below and can’t dry out. That’s a membrane or underlayment failure, not a fan that’s too small.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For Homestead, the installed range on a full bathroom remodel is $9,000 – $28,000. A small bathroom runs $5,000 – $12,000. If the job is a targeted piece – a shower replacement or a tub-to-shower conversion – the line items are $3,000 – $8,500 and $3,500 – $10,000 respectively. A walk-in shower runs $4,500 – $12,000, and a vanity install is $800 – $3,000.
| Scope | Installed Range |
|---|---|
| Full bathroom remodel | $9,000 – $28,000 |
| Small bathroom remodel | $5,000 – $12,000 |
| Walk-in shower installation | $4,500 – $12,000 |
| Tub-to-shower conversion | $3,500 – $10,000 |
| Shower replacement | $3,000 – $8,500 |
| Vanity installation | $800 – $3,000 |
What drives you toward the top of that range: extent of water damage behind the wall, whether the roof above needs attention, tile size and finish choice, and whether the layout moves plumbing. Every quote is a flat written price with a written scope and a written warranty before work starts. If the work reveals something hidden – a rotted subfloor under the tile – the change is written, priced, and signed before it happens. That’s Clause 1 of the Haven Standard. The 365-Day Done Right Promise backs the work.
DIY or Call Us?
What you can safely do: check for stains, photograph labels, tap tile for hollow spots, look under the vanity for moisture, and note whether anything smells musty after a fan has run. What you shouldn’t do: pull shingles, cut into a wet wall cavity, or reset tile over an unknown substrate. Those three moves turn a $400 repair into a $9,000+ remodel more often than they fix anything, and cutting into a wall with active moisture is how mold spreads into rooms that were dry.
Anything involving roof-level work or high-tension or hidden systems is a trained-professional job – not because it’s mysterious, but because the failure mode is expensive. If your bathroom sits under a Tamko roof and you’re seeing water, call (844) 834-4248 for a free estimate. We’ll document what we find with photos.
FAQs

Underlayment is a secondary barrier and its lifespan depends on exposure and install quality, not a single published number. In Homestead’s heat and UV load, an exposed underlayment degrades faster than a covered one, so how well the shingle layer above it was installed matters more than the underlayment brand. Call (844) 834-4248 for an inspection.
Sometimes, yes. A localized flashing repair or a single cracked tile with a sound substrate is a repair. A membrane or underlayment that has already allowed water into the wall or ceiling is not repaired by patching the visible surface – the material behind it has to come out. We’ll tell you which one you have, with photos. Call (844) 834-4248 for a free estimate.
A shower replacement is typically a multi-day job; a full bathroom remodel runs weeks, not days. Roof-level repairs factor into the schedule separately. The written scope you get before work starts includes the schedule window. Call (844) 834-4248 to schedule your free estimate.
We source by spec match and label match, not by guessing from appearance. Where a product line has an exact current equivalent, that’s the first choice; where it doesn’t, we show you the spec match and why it performs the same job. We don’t stock parts and we don’t carry inventory on trucks. Call (844) 834-4248 – estimates are free, and the price is always in writing first.
Rowan Construction Group Homestead is an independent contractor and is not affiliated with Tamko. Every quote is a flat written price before any work begins, with a documented photo record on every visit and a 365-Day Done Right Promise behind the work. Call (844) 834-4248 to schedule your free estimate, with a live person answering 24/7.
Written by the team at Rowan Construction Group Homestead, serving Homestead and nearby areas.












