







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tamko Driveway & Pavers: The Homestead Owner’s Guide
We install and repair Tamko-compatible driveway and paver systems in Homestead, and the numbers you’ll see for that work here run $7,000 – $18,000 for a full paver driveway installation and $3,500 – $11,000 for a paver patio. Smaller repairs and re-lays sit well below those figures. We are an independent service provider, not affiliated with Tamko, and we quote in writing before any work starts.
Owners usually find out something has gone wrong in stages. First a paver rocks underfoot when the morning sun hits it. Then a joint opens a quarter inch wider than the one beside it. Then the driveway starts shedding sand into the yard after every rain. By the time a paver pops loose near the apron, the cause is almost always underneath the surface – which is what makes this different from most parts on a house.
Which Tamko Models This Applies To

The word “Tamko” covers a lot of ground, so let’s be precise about what you’re matching. Tamko builds roofing shingles, waterproofing underlayments, and – relevant here – hardscape sealants and paver-related surface products; the company does not manufacture the pavers themselves. That distinction matters because when an owner says “I have a Tamko driveway part,” what they usually mean one of three things: a Tamko hardscape sealer or coating can, a Tamko waterproofing membrane under a paver or patio edge, or a specific paver profile matched to a Tamko sealant system during an earlier installation.
Identify what you actually have before ordering anything:
- Pull the label off the can or roll. Tamko product codes follow a letter-number pattern embossed on the side, not printed only on the lid – lids get lost.
- Measure a paver face-to-face across three units, not one. Homestead installations between 2015 and 2025 used several nominal sizes that look identical until you lay them in a course.
- Check the color code stamped on the paver edge. The same profile in a different dye lot will not blend, even under the same sealant.
On OEM versus aftermarket: for hardscape sealants, a quality aftermarket equivalent with the same solids content and base chemistry (acrylic vs. siloxane) does the same job at a lower price. For underlayment membranes under pavers, we generally stay with the specified product line because a mismatch in thickness changes how the base compacts. Our technicians have up to 19 years of experience reading those specs on-site.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tamko Driveway & Pavers Is Failing
These are the symptoms we actually see on Homestead driveways, and what’s causing each one.
- Paver heaves or rocks underfoot. The base is losing compaction, usually after water reaches a settled subgrade. In Homestead’s sandy soil, that happens faster than in clay or rock on the inland side of the county.
- Joint sand washes out after rain. Polymeric sand is failing, or was never locked in. Our summer downpours are enough to strip an unsealed joint in a single wet season.
- Efflorescence – white chalky bloom on the surface. Moisture is migrating through the pavers and depositing salts as it evaporates. It points to a drainage or base issue, not a cosmetic one.
- Edges sinking or spreading at the apron. The edge restraint has failed, or was installed without a proper mortar bed. Pavers creep outward and the whole field loosens.
- Sealer turning cloudy or peeling in sheets. The original coating was applied over damp pavers or the wrong base chemistry was used. Recoating over a failed film makes it worse.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what this work actually costs in Homestead, in dollars you can screenshot and compare:
| Scope | Installed price |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Paver patio installation | $3,500 – $11,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
The top of each range reflects larger square footage, tighter pattern work, or a full tear-out and base rebuild. The bottom reflects straightforward re-lay or sealing over sound substrate. What drives the number more than anything is what we find under the surface once a few pavers come up – and that’s exactly why we quote after we’ve looked, not before.
Every quote is a flat written price with a written scope, so parts, labor, base material, and edge restraint are all line-itemed. Nothing proceeds on a change without your signed change order. The work is covered by our 365-Day Done Right Promise: if it isn’t done right, we make it right.
DIY or Call Us?
Some of this is safely within reach for a careful homeowner. Re-sanding joints with fresh polymeric sand, pulling a single loose paver to inspect the base beneath, and cleaning efflorescence with a proper cleaner are all reasonable weekend work. What we’d steer you away from is a full re-lay or base rebuild without a compaction check, because a driveway installed over uncompacted fill will heave again within a season – and the fix costs more the second time. If your pavers are moving at the edges or the base is soft, that’s the point to call. Call (844) 834-4248 for a free estimate, and we’ll put the number in writing before anyone picks up a tool.
FAQs

A properly sealed paver driveway in Homestead holds its finish for about 3 – 5 years before the sealer needs refreshing, and the pavers themselves last decades if the base stays sound. Homestead’s heat and summer rain load the sealer faster than a drier climate would, so plan on a reseal cycle shorter than what northern product guidance assumes.
Often, yes. If the failure is isolated to a joint, a single course, or a sealer film, we re-sand, re-set, or strip and reseal without touching the rest. A full replacement is only necessary when the base has failed across the whole field or the edge restraint has given way.
A reseal takes one day. A joint re-sand and spot re-lay of a few pavers takes half a day. A full paver driveway rebuild runs 3 – 5 days depending on square footage and how much base has to come out. We give you a schedule in the written quote.
We match by product code, paver profile, and color lot before ordering. For sealants and membranes we work from the spec on your existing product or the original installation, and we’ll tell you in writing whether we’re using OEM or a quality equivalent and why. Bring a competitor’s written estimate and we’ll review it line by line at no charge.
We also work with KraftMaid, Cambria, and Silestone on adjacent projects, and our teams are background-checked and uniformed with a live person answering calls 24/7. Every visit includes a documented photo record as a standard deliverable, so you see what we found and what we did.
Call (844) 834-4248 to schedule your free estimate. We’ll look at the pavement, explain what’s underneath in plain terms, and hand you a written price before any work begins.
Written by the team at Rowan Construction Group Homestead, serving Homestead and nearby areas.












