







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
PGT Fence Installation: The Homestead Owner’s Guide
PGT fence installation in Homestead typically runs $3,500 to $9,000 for a standard residential run, and scheduling usually takes days rather than weeks because PGT-compatible panels and posts are ordered to the exact opening rather than cut on site. We handle the measurement, the permit paperwork Miami-Dade requires for anything over six feet, and the install as one written job. Rowan Construction Group Homestead is an independent contractor and is not affiliated with PGT.
Owners usually discover the problem one of two ways. Either a post has leaned after a wet-season soaking and the gate drags along the ground, or the panels are racked out of square after a storm gust and the latch no longer catches. In Homestead’s coral-rock-and-fill lots, the post footing is almost always the first thing to go, not the fence itself. That distinction matters because it changes what you actually need replaced and what it should cost.
Key takeaways:
- Installed range in Homestead: $3,500 to $9,000, with the written price delivered before work starts.
- Footings – not panels – are the most common failure on deep-sand and fill lots.
- PGT-compatible parts fit factory tolerances; field-cutting an existing PGT run voids the clean line and usually shortens its life.
Which PGT Models This Applies To

PGT makes several residential fence and railing product lines, and the part you order depends on which line your run belongs to. Before ordering anything, we identify three things: the post gauge, the post cap profile and the panel spacing. Those are stamped or embossed on the post cap or on a manufacturer tag attached near the gate hinge. If a tag is missing because the original installer pulled it or it weathered off, we measure the post centerline spacing directly, typically taken from the inside face of one post to the inside face of the next.
The compatibility gotcha most Homestead owners run into: PGT’s aluminum lines and its vinyl lines have different post-wall thicknesses, and a post cap from one will sit loose on the other even at the same nominal size. We measure the wall thickness with a caliper ourselves rather than trusting the box what the last contractor wrote on it. For vinyl, OEM panels and quality aftermarket panels generally match well, so we quote both and show you the price difference. For aluminum, we stick to OEM or equivalent because the rail profile is engineered as a unit and a mismatched rail is where gates start to sag within a season.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your PGT Fence Installation Is Failing
- A post has leaned. Usually soil washout from our summer downpours under a footing that was set too shallow or in sandy fill. The panel itself is fine; the base is the problem.
- The gate sags and drags. The top hinge pulled out of soft post material, or the post is no longer plumb. A gate that drops even a quarter-inch will catch the strike plate.
- Racked panels after a storm. Wind pushed the run out of square and the pickets no longer read true. In aluminum this shows as fasteners loosening; in vinyl as pickets staying put while the rails shift.
- Cracked or chalky vinyl. UV beating down year-round breaks the surface down fast. Chalking is cosmetic; a hairline crack through the picket face is not, and it gets worse each wet season.
- Rust at the fasteners or base. Salt air off the bay reaches inland and corrodes cheap hardware well before the post or panel shows a problem. The fence looks fine until a screw head pops.
Replacement Cost & What’s Included

Fence installation and replacement in Homestead fall in the $3,500 to $9,000 range for a standard residential side-yard or back-yard run. What drives the number is total linear feet, gate count, footing depth and whether we’re setting new posts or reusing sound ones. Our written quote separates materials and labor line by line, so you can see the cost of the panels, the posts, the concrete for the footings and the hardware as separate items. That structure is the reason “what’s the number” gets a real answer.
Every fence job gets the written scope and written warranty before a tool is picked up. Under Clause 1 of the Haven Standard, no work proceeds on any change until you sign a change order. That’s how a $3,500 to $9,000 job stays a $3,500 to $9,000 job instead of drifting. The 365-Day Done Right Promise covers the installation itself for a full year; if a post leans or a gate sags inside that window for reasons of our work, we make it right.
We also install KraftMaid cabinets, Cambria and Silestone counters and fixture packages when the same job calls for interior work. Different trade, same written-price discipline.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Fence work is less dangerous than garage-door springs or a panel swap, but a post footing is heavier physical work than most owners expect and a leaning post set in the wrong fill will lean again by the next rainy season. Here’s the honest split:
What you can check safely: Is the post itself cracked or is the whole thing leaning? Are the gate hinges loose or is the post no longer plumb? Is the picket face cracked through or just chalky? These three checks tell you whether you’re looking at a $100 hardware swap or a proper footing replacement.
Where DIY goes wrong: Reusing a post that’s still leaning, setting a new post in our sandy fill without digging deep enough for the concrete to grab, and field-cutting a vinyl or aluminum panel to fit an opening that wasn’t squared. Every one of those shows up as a re-lean or a rusted-fastener call within a year.
Call (844) 834-4248 for a free estimate. Written price, written scope, and a photo record of what we found before the crew arrives.
FAQs

A properly installed PGT vinyl or aluminum fence typically lasts 15 to 25 years in South Florida conditions, but that number assumes footings that reach below the sandy topsoil and hardware that stands up to salt exposure. Where installs fail early here, it’s almost always footing depth and fastener corrosion, not the panel itself. Our written quote states exactly what we’re setting and how deep, so you can compare it against what a shorter-lived install would cost. Call (844) 834-4248 for an exact quote – estimates are free.
Often yes. A leaning post can usually be reset and a single cracked panel replaced without touching the rest of the run, and a dragging gate is usually a hinge and plumb correction rather than a full swap. The judgment call is whether the underlying footing or the panel face has gone soft enough to keep failing. We inspect and tell you plainly which is the smarter spend. Call (844) 834-4248 and we’ll price both options in writing.
A standard residential run in Homestead typically takes one to three days once materials arrive, with larger runs and multiple gates adding a day. The timeline we quote accounts for digging footings in coral-rock-and-fill lots, which can be slower than pure sand. Weather in the wet season slows a footing pour while concrete cures. Your written scope states the expected window. Call (844) 834-4248 to schedule your free estimate.
We order PGT-compatible components after measuring your post spacing, post-wall thickness and cap profile, then match them against OEM and proven aftermarket equivalents before the quote goes out. Rowan Construction Group Homestead is an independent contractor and is not affiliated with PGT, so we tell you the source and the price difference openly. No parts sit in a truck or a warehouse waiting; every order is placed against your specific measurements. Call (844) 834-4248 for a written quote.
Contact Us for a Free PGT Fence Installation Estimate in Homestead
If a post is leaning or a gate won’t catch, the useful next step is a written price, not a phone call that ends in “someone will get back to you.” Call (844) 834-4248 to schedule your free estimate. We’ll measure the run, identify the PGT line, show you the line-item price for panels, posts, footings and hardware, and answer every question on the way to a signed scope. Our technicians have up to 19 years of experience, and every crew member is background-checked and uniformed before they arrive at your gate. The 365-Day Done Right Promise covers the install for a full year.
Written by the team at Rowan Construction Group Homestead, serving Homestead and nearby areas.












