







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Kitchen Remodeling: The Homestead Owner’s Guide
Mr-Glass kitchen remodeling in Homestead runs $14,000 – $45,000 installed, depending on whether you’re reworking cabinets and counters only or opening walls and rerouting plumbing. A smaller scope lands at $9,000 – $20,000. We’re an independent contractor and not affiliated with Mr-Glass, but we work on the cabinet systems and panel products sold under that label often enough to know where they fail in South Florida.
Most Homestead owners don’t discover a failing kitchen component in one dramatic moment. It shows up as a cabinet door that won’t sit flush after a wet season, a drawer box that sags under the weight of cast-iron pans, or a toe kick that has swollen and pulled away from the floor. By the time the second hinge gives out on the same door, the underlying problem (usually moisture, sometimes a wrong-weight hardware match) has been working on the wood for months.
What we do: match the part or panel to your specific Mr-Glass model line, quote a flat written price before anyone touches a tool, and leave you with a documented photo record of what we found and what we replaced.
Which Mr-Glass Models This Applies To

Mr-Glass cabinetry and panel products show up across several series, and they do not share hardware. A drawer slide from one line will not bolt into another. That’s the compatibility gotcha that costs Homestead owners a weekend of returns: the hinge plate screw spacing changes between box depths, and the shelf-pin diameter on older lines is 5mm while newer boxes use 6.3mm. Measure the pin hole with a caliper before you order anything.
To identify your line, look for the manufacturer label stuck to the inside face of the cabinet box, usually on the upper side of a base cabinet or the back panel of a wall cabinet. It lists the series, the box depth, and often a date code. Photograph it. If the label is missing, measure three things: the interior box depth, the door overlay (how far the door edge clears the cabinet frame), and the hinge cup diameter. Those three numbers narrow it to a series in most cases.
On the OEM-versus-aftermarket decision: for structural parts like drawer boxes and hinges, matched OEM or a quality equivalent built to the same overlay spec is the safer call. For cosmetic parts like a replacement door front on a discontinued line, a good aftermarket fabricator can match the profile and finish at a lower cost. We’ll tell you which side of that line your part falls on before we quote it. We also source across other major cabinetry and countertop lines, including KraftMaid, Cambria, and Silestone, so a mixed kitchen doesn’t force a single-source decision.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Mr-Glass Kitchen Remodeling Is Failing
Here’s what we actually see on inspections in Homestead, and what’s usually behind each one:
- Doors that won’t stay aligned after a wet season. The hinge screws have stripped out of damp particleboard, or the box itself has swelled. Adjusting the hinge won’t hold if the substrate has softened, which is common in kitchens without a working exhaust vent.
- Drawer boxes that sag or drag. The slide is under-rated for the load, or a roller has worn flat. Cast-iron cookware in a 50-pound-rated drawer will kill the slide in a year or two of daily use.
- Toe kicks pulling away from the floor. Water from a slow supply-line drip or a mopped floor has wicked into the toe kick board. By the time it separates, the cabinet base is often soft at the corner.
- Countertop seams that open or darken. Movement in the cabinet base below, or failed seam adhesive. A dark line along a quartz seam usually means moisture has entered and the substrate is flexing.
- Soft spots or bubbling on panel faces near the sink and range. Steam and splash exposure on a panel product not rated for wet zones. Once the face lifts, the core is exposed and the failure spreads.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

In Homestead, Mr-Glass kitchen work prices out in these ranges. These are installed numbers, parts plus labor, quoted as a flat written price before work starts:
| Scope | Installed Price Range |
|---|---|
| Full kitchen remodel | $14,000 – $45,000 |
| Small kitchen remodel | $9,000 – $20,000 |
| Cabinet installation | $4,000 – $13,000 |
| Countertop installation | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
What drives the range: box count and door style, whether plumbing or electrical has to move, countertop material and edge profile, and whether the existing cabinets come out clean or come out damaged. A cabinet swap in a kitchen with intact walls sits at the low end. A kitchen where we’re opening a wall, rerouting a supply line, and reconfiguring the island sits at the high end.
Every quote is itemized: parts, labor, and any permit line, all in writing before anyone starts. Under our upfront pricing standard, the number you agree to is the number you pay. Any mid-job change requires a signed change order first. The work carries our 365-Day Done Right Promise, and you get a documented photo record of the install on every visit, included as standard.
DIY or Call Us?
Some of this you can check yourself safely. Measuring the cabinet box, reading the label, photographing the failing hinge, and confirming the shelf-pin diameter are all fine to do with a tape and a caliper. That information actually makes our quote faster.
Where DIY goes wrong: re-hanging a door on a swollen box, cutting in a new countertop seam, and tearing out a cabinet that hides a live supply line or a shared wall. We’ve been called out to Homestead jobs where a homeowner removed a base cabinet and found a shutoff valve behind it, or where a new toe kick was screwed into a substrate that was already soft. The fix cost more than the original job would have.
If you’re not sure which side of the line you’re on, call (844) 834-4248 and describe what you’re seeing. We’ll tell you whether it’s a check-it-yourself or a book-a-visit situation, and the estimate is free either way.
FAQs

Seven to fifteen years for hinges and slides in normal use, and longer for the box itself if the kitchen vents properly. Homestead’s humidity is the variable most owners underestimate. A kitchen with a working range hood and no supply-line drips will outlast the same cabinets in a house where the exhaust just recirculates. Call (844) 834-4248 for a free estimate if yours are past that window and starting to fail.
Sometimes, yes. A single stripped hinge screw can often be fixed with a wood insert and a longer screw, and a misaligned door can be re-hung if the box is sound. A swollen box, a soft toe kick, or a countertop with an open seam usually needs replacement of the affected section, not a patch. We’ll tell you which it is after we look. Estimates are free.
A single cabinet or a countertop section is usually a one- to two-day job once the part is on site. A full cabinet run with counter and backsplash runs five to ten working days, and longer if plumbing or electrical moves. The written quote includes the schedule. Call (844) 834-4248 for an exact timeline on your kitchen.
We match it by series, box depth, overlayment, and hinge or slide spec from the label and measurements, then source OEM where it’s structural and a quality equivalent where it isn’t. We don’t claim to stock parts locally. We order to your spec and confirm fit before install. Call (844) 834-4248 to start with a free estimate.
Whether you’re patching one failing cabinet in a Homestead kitchen or planning a full remodel, the starting point is the same: a written price and a written scope before any work begins. Call (844) 834-4248 for your free estimate, and bring any competing quote if you have one. We’ll review it line by line at no charge under our Free Second Opinion offer.
Written by the team at Rowan Construction Group Homestead, serving Homestead and nearby areas.












