







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Roofing: The Homestead Owner’s Guide
Mr-Glass roofing repairs in Homestead typically run $400 to $1,800, and a full Mr-Glass-compatible replacement runs $8,000 to $20,000 installed, depending on the panel or tile count and the deck condition underneath. We source Mr-Glass roof panels, tiles, ridge caps, and the specialty fasteners and sealants that go with them, then install them with a written price before any work starts. Most Homestead owners find out something is wrong the same way: a brown water stain spreads across a ceiling after an afternoon storm, a panel lifts and flaps in a tropical gust, or a walk-around after heavy rain turns up cracked sealant and a curled edge at the ridge.
Why this page is Mr-Glass-specific
Mr-Glass makes roof panels and tiles with their own trim profiles and fastener patterns, and the failure points don’t match generic asphalt shingles. We wrote this page for the owner who already knows the brand on their roof and needs the part matched, priced, and installed. Rowan Construction Group Homestead is an independent service provider and is not affiliated with Mr-Glass; we install and repair their products as a service. Under Clause 1 of The Haven Standard, you get a flat written price and written scope before any work begins, on every roofing job.
Which Mr-Glass Models This Applies To

Mr-Glass sells several roofing product lines, and the panel profile, thickness, and fastener spacing change between them, so the part that fits one won’t seat on another. Before we quote, we read the product label printed on the back of a panel or the underside of a tile and match it to the exact series. If the label is faded or gone, we measure the panel width, the rib pitch (the distance between raised ridges), and the length, then confirm the profile against the original spec.
The compatibility gotcha that trips up most owners: Mr-Glass trim, ridge caps, and closure strips are matched to a specific panel line, so a cap from the wrong series won’t sit flush and leaves a gap that wind and rain find within a season. On the OEM-versus-aftermarket question, a factory Mr-Glass panel matched to your existing profile is the sure fit; a quality aftermarket equivalent can work for a like-for-like panel if the rib pitch and thickness match exactly, but on a partial repair, matching the original profile matters more than the label. We tell you which route we’re taking and why in the written quote, so you can compare. Our technicians have up to 19 years of experience reading these profiles.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Mr-Glass Roofing Is Failing
- Water staining on ceilings or walls. The stain shows where water pooled inside, but the leak usually starts higher up at a lifted panel seam, a failed fastener gasket, or cracked sealant at a penetration, and follows the deck until it finds a low point.
- Panels lifting or flapping in wind. Lift starts at the fasteners or edges. A missing or backed-out fastener, or a gasket worn by sun and salt air, lets wind get under the panel and work it loose.
- Cracked or dried sealant at seams and ridge caps. Florida’s heat and humidity break down sealants faster than owners expect, opening a path for water at the very joints meant to keep it out.
- Rust or corrosion on fasteners and metal trim. Salt air near the coast speeds corrosion, and a corroded fastener loses its grip and its seal, which is why the fasteners fail before the panel does.
- Curling, cracking, or granule loss at panel edges and tiles. Sun exposure at the edges plus wind-driven rain, common in Homestead’s storm season, wears the material, and once it cracks, water gets behind it and the deck below starts to soften.
Replacement Cost & What’s Included

Here’s what Mr-Glass roofing work costs in Homestead, quoted as a flat written price before any work starts:
| Job | Installed range |
|---|---|
| Roof repair (panels, sealant, fasteners) – $400 to $1,800 | |
| Roof replacement – $8,000 to $20,000 | |
| Tile roof repair – $600 to $2,500 | |
| Metal roof installation – $15,000 to $40,000 |
The range depends on the count of panels or tiles, the condition of the deck (soft deck under a leak adds cost), the pitch and height of the roof, and whether fasteners and trim must be replaced with the panels. Every quote is line-item: parts, labor, and disposal listed separately, so you can see where the number comes from. The installation carries a written workmanship warranty, and the 365-Day Done Right Promise backs the whole job.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
An owner can safely do a few things from the ground: photograph the stain, look for lifted panels or missing fasteners from a ladder set on firm footing, and check the product label on a panel. What we don’t recommend is climbing onto a steep or wet roof to replace or seal a panel yourself.
Roof work is height work, and in Homestead’s heat, one slip on a pitched panel causes the kind of injury we see in the trade. Alongside the fall risk, a DIY repair usually fails at the detail: the wrong-profile trim, an under-driven or over-driven fastener that crushes the gasket, or sealant applied over a damp surface that lets go after the next storm. Panels aren’t confined to the ground. So is getting the part matched to the profile. Call us at (844) 834-4248 and we’ll price the fix and tell you honestly whether it’s a small repair or a partial tear-off.
FAQs

A well-installed Mr-Glass roof typically gives 20 to 30 years before a full replacement, but the fasteners and sealant at the seams often need attention earlier in Florida’s heat, sun, and storm season. Salt air speeds up corrosion at the coast, so coastal roofs need fastener inspections sooner. Call (844) 834-4248 for a free estimate on the repair or replacement.
Often, yes. A single lifted panel, a few failed fasteners, or a cracked seal at a penetration is a repair, and the $400 to $1,800 repair range usually covers it. Replacement makes sense when the damage is widespread, the deck underneath has soft spots, or the panels are past their service life. We inspect the deck and tell you which one you’re looking at, with the price for each. Call (844) 834-4248 for a free estimate.
A targeted repair is usually done in a day, while a full panel or tile replacement depends on the roof size and deck condition and is typically a multi-day job. We’ll put an honest schedule in the written scope before the crew arrives. Call (844) 834-4248 for a free estimate and a written timeline.
We match the part by reading your existing panel’s product label and measuring its profile, rib pitch, and thickness, then sourcing the factory or quality aftermarket equivalent that fits that exact spec. You get the part specified in the written quote, so you know what’s going on your roof. We also service KraftMaid, Cambria, and Silestone brands for the rest of your home. Call (844) 834-4248 for a free estimate.
Get Your Mr-Glass Roofing Priced in Writing
Every Mr-Glass roofing job we do starts with a written price and written scope, backed by the 365-Day Done Right Promise. Call (844) 834-4248 for a free estimate on your Homestead roof, or bring a competitor’s written quote and we’ll review it line by line at no charge. Our calls are answered by a live person 24/7, our crews are background-checked and uniformed, and every visit includes a documented photo record of what we found and what we fixed.
Written by the team at Rowan Construction Group Homestead, serving Homestead and nearby areas.












