







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Belgard Kitchen Remodeling: The Homestead Owner’s Guide
Belgard kitchen remodeling in Homestead typically runs $14,000 to $45,000 installed, depending on layout, cabinet line and whether walls move, and we build that number into a written quote before anyone picks up a tool. Small kitchens land closer to the $9,000 to $20,000 end of that scale; full tear-outs with new cabinets, counters, island and backsplash sit at the top. Most Homestead owners don’t arrive at this decision through a catalog. They arrive because the kitchen is telling them something is wrong.
The failure shows up in small ways first: a door that won’t close flush, a cabinet box pulling away from the wall along the base, a counter seam that has lifted a hair above the surface. Around Homestead, that pattern has a cause worth naming before we get further. Many homes built through the 1990s and 2000s used particleboard cabinet boxes and particleboard substrate under the counters. In a kitchen with no vapor control, tile-direct-to-substrate construction, or an older swamp cooler retrofit, the material under the finish picks up ambient moisture over years of Miami-Dade summers. The finish stays intact and looks fine. The structure underneath doesn’t.
Clarity on one point before the rest: Rowan Construction Group is an independent contractor. We aren’t affiliated with Belgard, we don’t sell Belgard-branded products, and we don’t mix the two businesses in a quote. What we do is build kitchens around Belgard hardscape and surface lines where an owner has already chosen them, and quote the work in a flat written price with a signed scope and a written warranty.
Which Belgard Models This Applies To

Belgard makes its name in hardscape: pavers, retaining walls, fire features. For indoor kitchen work, the relevant product lines are the surface and finish groups, not the driveway and patio lines. If you’re comparing Belgard with other surface and paver families, know that KraftMaid, Cambria and Silestone cover the cabinet and countertop side of most Homestead jobs; Belgard sits on the hardscape and surface side. When those two worlds meet in an open-plan kitchen that flows into a covered patio, coordinating the hardscape pavers with the floor finish is a real design-and-spec point, not an aesthetic afterthought.
Identifying the right part starts with the label, not the brochure. Most Belgard surface and hardscape products carry an imprint or date stamp on the back, edge or underside. A 3-inch stack of old samples in a kitchen drawer can’t substitute for a label; the product family and the color name are on the piece, not in memory. Measure in inches and note the nominal versus actual size: 12×12 tile and pavers are frequently 11-5/8 to 11-7/8 once installed, and matching new stock to that actual dimension across a room where the expansion gap is set is the difference between a flush run and a visible stepped edge at the transition.
OEM versus aftermarket is a real decision here. Belgard’s own accessory pieces (tile trim, edge restraints, transition strips, matching grout colors) are the only guaranteed match for a specific product family. Quality aftermarket pieces from established tile and paver suppliers are often identical in dimension and material. The failure point isn’t the quality of the aftermarket piece; it’s choosing a part for the right look but the wrong substrate compatibility. That’s where a sample card helps and a quick call saves frustration.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Belgard Kitchen Remodeling Is Failing
These are the symptoms we hear about in Homestead most often. Each one points to a different underlying cause, so what looks like one problem can be two or three.
- Tile or paver joints that stay damp and dark. Water is sitting under the surface because the thinset layer or grout has failed, not because the tile itself is bad. In full sun and high humidity, that condition feeds mold growth under the finish within one season of Miami summers.
- Hairline cracks running through grout lines, or a paver that rocks when stepped on. The substrate has shifted, and the deflection is transferred to the finish above it. A paver that rocks in a kitchen floor is not seasoning; it’s a sign the base was thinner than the spec.
- Efflorescence, a white powdery bloom, on the surface. Efflorescence is salt pushed to the surface as water moves through the slab or paver. It’s a water-management symptom, and it appears on the surface first, so a surface-only fix doesn’t last.
- Countertop seams lifting, or the surface peaking near the wall. Cabinet boxes under the counter have absorbed moisture and swelled at the wall base, raising the substrate and lifting the finish. The seam is a symptom; the cabinet structure is the cause.
- Cabinet doors that stick, or drawer boxes that ride the rail. Boxes are out of square because the wall behind them is settling or the cabinet was never shimmed properly. This one is common in Homestead homes where the original install was on tile-direct-to-slab without a leveling layer.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s the number we put in writing before we start, and the line items a Homestead owner should expect to see in a quote.
| Kitchen work | Installed range |
|---|---|
| Full kitchen remodel (written scope) | $14,000 – $45,000 |
| Small kitchen remodel | $9,000 – $20,000 |
| Cabinet installation | $4,000 – $13,000 |
| Countertop installation | $2,000 – $6,500 |
| Backsplash installation | $800 – $2,500 |
| Kitchen island installation | $3,000 – $10,000 |
What drives the range is layout and structure, not finish. A kitchen with running plumbing and no wall removals lands closer to the $14,000 end. A kitchen where the cabinet boxes have swollen and the substrate needs replacing before new cabinets go in lands at the higher end because the demo and rebuild are part of the number.
Every Rowan quote is a flat written price with a written scope and a written warranty. Change orders only happen when the scope actually changes, and nothing proceeds until the change order is signed. We’re happy to provide a written quote the owner can compare line by line against another contractor’s.
DIY or Call Us?
An owner can safely check these things: lift a tile corner that has already popped, photograph the substrate under it, note the presence of any stamp or label on the back of the removed piece, and measure the actual dimensions of the tile or paver. Do those four things and you’ll know more about the failure than most calls give us.
Where DIY goes wrong is exactly where most owners start: prying up a stubborn piece, lifting the tile at a seam, cutting grout with a rotary tool. Two things happen. The tile or paver is likely to break along the lift line, and the subfloor or substrate underneath comes up with it. The failure you started with is a cracked finish; the failure you end with is a damaged subfloor and a bigger job. Tile and paver removal also sends a small amount of silica dust into the air, and that means respirator and eye protection at minimum.
Call (844) 834-4248 and describe what you found. We’ll give you a written scope and price before anyone shows up. Free second opinion on any written estimate you already have, line by line.
FAQs

A properly installed Belgard-surface kitchen floor over a correct substrate should last 15 to 25 years. The surface isn’t the weak point in Florida; water management under it is. Homes where the substrate is properly sealed and the transition to the slab is correct routinely go 20 years without lifting, and we see sealed installs outlast unsealed ones by a clear margin in our own jobs.
Call (844) 834-4248 for an exact quote on replacing a failing surface, estimates are free.
Sometimes, yes. A single popped tile with intact substrate underneath can often be reset. A rocker paver can sometimes be lifted and re-bedded. What can’t be repaired with a surface patch is efflorescence or a persistent damp joint, because those point to the substrate and moisture below, not the surface. We’ll say what we found before recommending either path.
Call (844) 834-4248 for an exact quote once a technician has seen the piece.
A single-tile repair is often done the same visit. A full backsplash or a partial floor re-lay typically runs one to two days. A full kitchen floor over new substrate is a one-to-two-week project once demo is included. The written quote carries the timeline before work starts.
Call (844) 834-4248 to schedule a review and get the days in writing.
We work from the imprint or stamp on the existing piece, the actual measured dimensions, and a photo of the substrate under the failed tile. From that, we source from Belgard’s product family as the first option and match to a like-dimension equivalent when the family is discontinued. Every quoted job lists the sourced product line and dimension so the owner sees exactly what’s going in.
Call (844) 834-4248 with the label info and a photo, and we’ll confirm sourcing before quoting.
Written by the team at Rowan Construction Group Homestead, serving Homestead and nearby areas.
Ready for a written price before any work starts? Call (844) 834-4248 for a free estimate. Every Rowan job comes with a written flat price, a signed scope, and the 365-Day Done Right Promise, which means if it isn’t done right, we make it right. Documented photo record on every visit, background-checked and uniformed technicians, and a live person answering the phone 24/7.












