







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CGI Driveway & Pavers: The Homestead Owner’s Guide
We install CGI-compatible paver driveways and hardscape in Homestead, with installed paver driveway pricing typically running $7,000 – $18,000 and concrete alternatives at $4,500 – $12,000, quoted as a flat written price before any work starts. Scheduling is planned rather than same-day, because pavers need a proper base, drainage and cure time under South Florida conditions. Most Homestead owners discover the failure the same way: a low spot that holds water after every summer storm, joints that keep washing out no matter how often they’re re-sanded, or pavers that rock underfoot where the base has settled over the limestone and muck soils common across Homestead. When the base fails, replacing individual pieces doesn’t hold. The repair is a rebuild of the section.
Which CGI Models This Applies To

CGI makes a range of driveway and paver profiles, and the part that fails is almost never the surface unit. It’s the base, the joint sand or the edging restraint holding the field together. When we quote a repair, we identify your existing paver by dimensions, thickness and face profile, not by name alone. CGI pavers typically run 60mm thick for driveways and 40mm for patios, and a straight swap from a 40mm patio unit into a driveway field is a mistake we see regularly, because the thinner unit cracks under vehicle loads.
To match a replacement, we measure the length, width and thickness of a pulled unit, photograph the face and edge profile, and check whether the field was laid in a running bond, herringbone or basketweave. That pattern determines how the repair blends. OEM CGI pavers give an exact color and texture match to the existing field. Quality aftermarket equivalents are usually a better value on older installs where the original color has weathered and an exact CGI match would look out of place anyway; we’ll tell you which route makes sense once we’ve measured. Matching matters most on a repair beside a visible area; less so on a full-section rebuild.
Rowan Construction Group Homestead is an independent service provider. We are not affiliated with CGI.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CGI Driveway & Pavers Is Failing
- Water pooling in the same low spots after rain. The base under that section has settled or the field has lost its slope toward the drain, so water sits instead of running off. In Homestead’s wet season, that standing water finds every weak joint.
- Joint sand washing out within weeks of re-sanding. Sand that disappears that fast means the joints are too wide or the base is moving underneath. Re-sanding alone won’t hold it.
- Pavers rocking or shifting underfoot. A paver that moves was never properly bedded or the base has failed. Left alone, the movement spreads to neighbors and opens joints for weeds and water.
- Edging restraint lifting or pulling away. The edge restraint keeps the whole field locked in. When it lifts, the outer courses spread and the pattern loosens from the perimeter inward.
- Efflorescence and standing-water staining that keeps coming back. White mineral bloom on the surface usually traces to moisture trapped from below, not the top. Cleaning it treats the symptom; fixing drainage treats the cause.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For a Homestead repair or partial rebuild, expect these installed ranges, parts and labor combined in one flat written price:
| Service | Installed price range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Driveway replacement | $5,000 – $14,000 |
| Paver patio installation | $3,500 – $11,000 |
| Driveway sealing | $250 – $700 |
The range is driven by square footage, whether the old base is reused or rebuilt, drainage corrections, and how closely the new field has to match existing pavers. A full paver driveway with base correction and drainage runs toward the higher end; a section repair or a seal-and-stabilize job sits near the bottom. Under Clause 1 of The Haven Standard, the price is written before anyone starts, and no change proceeds without a signed change order. The work carries our 365-Day Done Right Promise, and every visit includes a documented photo record of the base conditions we found and the finished repair.
DIY or Call Us?
Owners can safely check a lot from the surface. Walk the field after rain and mark where water pools. Pull one loose paver and photograph the base underneath. Read the pattern and measure a unit’s thickness. Those notes make a quote accurate. What goes wrong DIY is the base. A paver drive over an improperly compacted, improperly sized base will fail again within one or two wet seasons, and re-sanding or sealing over a failing base just hides it for a few months. Compaction and drainage are the trade’s real work.
If you’re not sure whether your issue is surface or base, that’s worth a look. Call (844) 834-4248 for a free estimate, and bring a previous quote if you have one; our Free Second Opinion reviews it line by line at no charge.
FAQs

How long do CGI pavers last in Homestead? A properly installed CGI paver field should last 25 to 30 years, but in Homestead the limiting factor is almost always the base and drainage rather than the paver itself, because heavy rain and the area’s soil movement stress the sub-base far more than in drier climates. A paver that was set on a shallow or poorly drained base can fail in under five years. Call (844) 834-4248 to get yours looked at.
Can the failed section be repaired instead of replacing the whole driveway? Yes, most often it can. A localized rebuild of the failed area, matching CGI pavers to the existing field, restores the drive at a fraction of a full replacement. We only recommend a full replacement when the base failure is widespread or drainage is wrong across the whole field. Call (844) 834-4248 for a free estimate and we’ll tell you which one you need.
How long does a paver repair or replacement take? A local section rebuild is usually a couple of working days, while a full driveway replacement typically takes several days once you account for base prep, laying and joint sand. Homestead’s rain can add a day or two, and we build that into the written schedule rather than treating it as a surprise. Call (844) 834-4248 to book an estimate.
How do you source the matching CGI pavers? We measure your existing unit, photograph the profile and confirm the pattern, then source OEM CGI pavers for an exact match or quote a quality aftermarket equivalent when that’s the smarter value on a weathered field. You see the part and the price in writing before anything is ordered or placed. Call (844) 834-4248 for a free estimate.
We also service KraftMaid, Cambria and Silestone across our other trades.
Whether you’re patching one failed section or rebuilding a driveway from the base up, the next step is the same: schedule your free estimate by calling (844) 834-4248. You’ll get a flat written price, a written scope and a written warranty before any work starts, and a documented photo record when we’re done. If you’re comparing bids, bring the other quote and we’ll review it line by line at no charge.
Written by the team at Rowan Construction Group Homestead, serving Homestead and nearby areas.












