







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
PGT Home Additions & ADU: The Homestead Owner’s Guide
A PGT impact-rated addition or ADU shell in Homestead typically runs $45,000 to $130,000 installed, depending on square footage, roof line, and how the new structure ties into your existing wind-load path. We are an independent contractor, not affiliated with PGT, and we build additions around PGT windows and doors every week. PGT doesn’t make a “part” for an addition the way it makes a sash or a roller – the product is the window and door package itself, and the enclosure around it is where things fail.
Homestead owners usually find the problem the same way: a window frame in the addition that has pulled away from the block after a wet season, a sliding glass door at the ADU entrance that stopped latching square, or water staining on the drywall under a PGT unit that everyone assumed was sealed. Hurricane Andrew rewrote the building code here in 1994, and the additions that pass inspection are the ones built to that code with PGT’s impact-rated glazing installed to PGT’s own anchoring schedule – not the ones where a framer guessed.
Which PGT Models This Applies To

PGT’s WinGuard and PremierVue lines are the ones you’ll see on Homestead additions and ADUs, in aluminum and vinyl frames. WinGuard is PGT’s impact line, with laminated glass and heavy-duty frames meant to take windborne debris – which is the whole point in a Miami-Dade County high-velocity hurricane zone. PremierVue is the non-impact architectural line used on interior partitions and covered lanais where the opening isn’t in the envelope.
Identifying the right unit starts with the label: every PGT window and door carries a permanent label with a product code, a Florida Product Approval number, and the design pressure rating. Photograph that label before anything else happens. The design pressure (DP) rating is the number that matters – a DP of 50 is common for residential openings, and a unit rated below what your addition’s plans call for will fail the county inspection no matter how well it’s installed. Measure the rough opening, not the unit. Replacement units are ordered to the rough opening minus the shim space.
OEM versus aftermarket is a real decision here, but not the one you might expect. For a failed window or door in an addition, there is no “aftermarket PGT-compatible unit” worth buying – the impact rating and product approval are tied to the specific tested assembly. What you can control is the hardware: rollers, locks, and weatherstripping have genuine PGT parts and quality equivalents. Match the roller by wheel diameter and axle type, and the lock by the keeper spacing on the frame. We also install KraftMaid and Cambria in additions where the ADU needs a kitchen or bath, but that’s a separate conversation.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your PGT Home Additions & ADU Is Failing
The failure mode in Homestead is rarely the glass. It’s the connection between the unit, the frame, and the block wall – and the water that finds the gap after a summer of afternoon storms.
- Water staining or soft drywall below the window. Usually a failed perimeter seal or missing flashing at the sill, not a glass problem. The water tracks behind the frame and shows up inside months later.
- A frame that has pulled off the block. Anchor corrosion or an under-driven anchor from the original install. In salt air near the coast, cheap fasteners fail first, and the opening goes out of square.
- A sliding door that drags or won’t latch. A worn roller, a settled track, or both. On PGT sliders the roller usually goes before the track, and swapping the roller is far cheaper than the door.
- Fogging between the panes. The seal in the insulated unit has failed. On impact glass this is a replacement, not a repair, and it’s covered less often than owners expect.
- A unit that won’t close flush in wind. The lock isn’t engaging the keeper. Either the lock hardware is worn or the frame has moved and needs re-shimming before the hardware is replaced.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s the honest split. A single PGT impact window replacement in a Homestead addition runs $800 to $2,500 installed, depending on size and whether the opening needs re-flashing. A sliding glass door replacement runs $2,000 to $6,000. If the problem is a larger structural tie-in – a detached addition or a settled ADU – you’re looking at the full range, $45,000 to $130,000. Garage conversions sit at $30,000 to $80,000, and full ADU construction at $90,000 to $220,000.
What drives the range: unit size and DP rating, whether the rough opening needs repair, whether the county requires a permit and inspection (almost always, in unincorporated Homestead), and finish work. Our written price is a flat number with a written scope before anyone picks up a tool. That’s Clause 1 of The Haven Standard. No change order proceeds without your signature. The work carries our 365-Day Done Right Promise – if it isn’t done right, we make it right.
DIY or Call Us?
You can safely check a few things. Look at the label and write down the product code and DP rating. Measure the rough opening. Test the lock and look at the keeper. Feel for soft drywall under the sill. Those checks cost nothing and tell you a lot.
What you shouldn’t do is reset anchors, re-flash an opening, or pull a PGT impact unit yourself. A mis-sealed impact window in a high-velocity hurricane zone doesn’t just leak – it voids the product approval, and the next inspection or insurance review finds it. The unit’s rating lives in the tested assembly, and the assembly includes the installation method. On a full addition or ADU, everything from the slab to the tie-in is permit work. Call (844) 834-4248 for a free estimate and a free second opinion on any written quote you’ve already got. We’ll review it line by line, at no charge.
FAQs

Twenty to twenty-five years on the unit itself, but the sealant and flashing around it need attention well before then – typically 8 to 12 years in South Florida’s sun and salt air. The glass is the durable part. The perimeter is what ages.
Sometimes. A dragging slider is usually a roller replacement, and a lock that won’t engage is often a hardware swap. Fogged insulating glass and a frame that has lost its anchor can’t be repaired – those are replacements. We tell you which before we quote.
A single window is a few hours. A sliding door is most of a day. A full addition or ADU is weeks of permit and construction time – the county inspection schedule sets the pace on those, not us. Your written scope lays out the phases and the dates.
Through PGT’s product approval and dealer network, matched to the label on your unit. We don’t carry parts on a truck and we don’t claim to. What we do is identify the exact code, order against it, and document what arrived with photos on every visit.
Call (844) 834-4248 for a free estimate on your PGT addition or ADU – we’ll give you the written price before any work starts, and a documented photo record when we’re done.
Written by the team at Rowan Construction Group Homestead, serving Homestead and nearby areas.












