







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Therma-Tru Bathroom Remodeling: The Homestead Owner’s Guide
Therma-Tru bathroom remodeling in Homestead typically runs $9,000 – $28,000 installed, depending on whether you’re keeping the footprint or moving plumbing, and most projects we quote are scheduled within a week or two of the signed estimate, not the same day. Smaller bathrooms land closer to $5,000 – $12,000. When a Therma-Tru door or its hardware is part of the scope, the failure usually shows up before the remodel does: a door that drags on the tile, a hinge that won’t hold adjustment, or a threshold gasket that has swollen after a wet season. Owners tend to find it the morning the door sticks and won’t shut all the way, or when a fiberglass slab near the shower base starts showing a soft spot.
We’re an independent contractor. We’re not affiliated with Therma-Tru, and we don’t sell parts off a truck. What we do is quote the replacement or the remodel around the part that’s actually failing, in writing, before anyone picks up a tool.
Key Takeaways
- Full bathroom remodel in Homestead: $9,000 – $28,000. Small bath: $5,000 – $12,000.
- Therma-Tru fiberglass and steel doors in South Florida fail more often at the gasket and threshold than at the slab itself.
- Every quote is a flat written price with written scope. No change proceeds without a signed change order.
- Free second opinion on any written estimate you already have.
Which Therma-Tru Models This Applies To

Therma-Tru builds interior and exterior doors under several lines, and the parts don’t cross over cleanly. Their Fiber-Classic and Smooth-Star door slabs each take different hinge and lockset preparations, and the rot-resistant bottom rails on the exterior-rated slabs are a different profile than the interior flat-slab doors. If you’re replacing a door inside a bathroom renovation, know which one you have before ordering anything. The label is usually on the hinge edge of the slab or on the top jamb; a stamped model number and a date code sit there together. Photograph it. That photo is what we ask for before quoting.
The OEM-versus-aftermarket decision matters more on older Homestead doors, where humidity and salt air have done their slow work. A genuine Therma-Tru replacement slab will match the frame and the weatherstrip channel exactly. A quality aftermarket slab can cost less, but you’ll be replacing hinges or trimming the jamb to make it fit, and in a bathroom, every gap is a place where moist air gets in. We source across fifty-plus vetted brands on the remodel side too – KraftMaid and Wellborn for vanities, Cambria and Silestone for tops – and we make the same call on each: match the spec, quote it flat, document it. We also handle KraftMaid, Cambria, and Silestone material as part of the same written quote.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Therma-Tru Bathroom Remodeling Is Failing
- The door drags or won’t latch. That’s usually a hinge that has pulled from the jamb, and in a bathroom it’s often moisture swelling the jamb wood underneath. Left alone, the whole hinge edge softens.
- The bottom gasket or threshold looks swollen or cracked. South Florida humidity attacks the sweep and the adjustable sill more than the door itself. Once the seal fails, water sits at the base of the slab.
- A soft spot or blister near the bottom rail. Fiberglass slabs can hold up for years, but a failed seal lets moisture into the rail and the damage shows as a bulge or a spongy feel under your thumb.
- Mildew that returns after every cleaning. It’s not a cleaning problem. It’s a ventilation and seal problem, and a bathroom without a working exhaust or a tight door invites it into the framing.
- The slab is out of square with the frame. You’ll notice daylight at a corner or a gap that changes with the weather. On an exterior bathroom door, that gap is a path for wind-driven rain.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Bathroom remodeling with a Therma-Tru door replacement in Homestead runs $9,000 – $28,000 for a full bath and $5,000 – $12,000 for a small one. A standalone door swap inside the project usually adds a few hundred to low four figures, depending on whether the frame is sound or has to be rebuilt. What drives the range: whether we move plumbing, whether the subfloor and cement board need replacing, whether tile goes to the ceiling, and whether the exhaust and lighting get upgraded to code.
Every quote is a flat price with written scope, and the price doesn’t move unless you sign a change order. Our technicians have up to 19 years of experience, and every visit includes a documented photo record – what we found and what we did – as a standard deliverable. Work is covered by our 365-Day Done Right Promise. If it’s not right, we make it right.
DIY or Call Us?
You can safely check a few things yourself: look for the model label on the hinge edge, run a finger along the bottom gasket to feel for swelling, check for daylight at the corners when the door is closed, and confirm the exhaust fan actually pulls air. Beyond that, this is where DIY gets expensive. Rehanging a door so it swings true inside a tiled jamb takes patience and the right shims, and cutting a new slab to fit an out-of-square frame is not a first-timer’s job. More to the point, the door is usually only one symptom – the soft jamb or the failing seal behind it is the real repair, and that means opening the wall. Call us at (844) 834-4248 and we’ll look at it with you.
FAQs

Expect 10 to 20 years from a well-sealed fiberglass or steel slab, and much less if the bottom gasket or threshold has been failing for a season or two. South Florida humidity and salt air wear the seals first, then the rail. Call us for a free estimate if yours is past 15 years and showing drag or softness.
Often yes – a hinge, a sweep, or an adjustable sill can be replaced without touching the slab, and that’s the cheaper fix when the frame and rail are still solid. A soft rail or a slab out of square usually means replacement. We’ll tell you which one it is in writing, with the reasoning, so you can decide.
A single door or slab swap in a bathroom usually takes a few hours, and a full bathroom remodel runs one to three weeks depending on tile, plumbing, and whether the framing needs repair. We put the schedule in the written scope before work starts, so you know what to expect.
We read the model number and date code off the slab or jamb, match the series and preparation, and quote the OEM part or a vetted aftermarket equivalent with the tradeoffs spelled out. We don’t claim stock, and we don’t carry parts. You get a written price before anything is ordered.
Call (844) 834-4248 to schedule your free estimate. If you already have a written quote from someone else, bring it. Our second opinion on any written estimate is free, reviewed line by line.
Written by the team at Rowan Construction Group Homestead, serving Homestead and nearby areas.












