







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wellborn Kitchen Remodeling: The Homestead Owner’s Guide
We install and complete Wellborn-compatible kitchen remodeling tasks for Homestead homeowners, and a full kitchen remodel here typically runs $14,000 to $45,000 installed, with cabinet-specific jobs like a door, drawer box, or hinge swap usually scheduled within a week or two. Wellborn makes a broad cabinet and component line, and the page you’re on is about matching the right part to the right Wellborn box or front so the finish, bore pattern, and overlay line up. Homestead owners usually find out something has gone wrong when a soft-close door won’t latch, a drawer front sags at the top corner, or the paint on a rail starts lifting months after a humid summer. That’s your first clue the part, not the cabinetry, has failed.
Which Wellborn Models This Applies To

Wellborn builds a few cabinet families, and the parts don’t cross over cleanly. The Woodbrook and Summerville lines run standard full-overlay hinges, while their framed lines use a partial-overlay hinge with a different bore offset. The part that actually matters is the door overlay and hinge bore, not the series name on the sales flyer. Before you order anything, look inside the cabinet door: Wellborn typically stamps or labels the box and the hinge plate with the line and a part code. If that label is gone, measure the hinge cup bore (usually 35mm on newer lines, but older installs run smaller) and the overlay distance from the door edge to the cup centerline. That single number tells you which hinge family you need.
On the OEM question for Wellborn specifically: match OEM when you’re replacing one door or drawer front and need the finish and profile to match the rest of the run, especially on painted finishes where dye lots and sheen drift between batches. Quality aftermarket equivalents are fine for hinges, soft-close dampers, drawer slides, and shelf clips, and a good Blum or Grass slide is often a straighter improvement than the factory original. For a full door or front, go OEM. Rowan Construction Group Homestead is an independent service provider and is not affiliated with Wellborn; we source Wellborn-compatible parts through vetted suppliers and tell you plainly which parts are factory and which are equivalents.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Wellborn Kitchen Remodeling Is Failing
- Door won’t stay closed or drifts open. The hinge spring has lost tension or the hinge plate screws have pulled out of the wood. In Homestead’s humidity, the plate screws loosen faster than you’d expect because the wood swells and shrinks across the season.
- Soft-close action is gone or jerky. The damper fluid in the soft-close hinge or slide has dried out or cracked. This is common on cabinet runs near a range where heat cycles the mechanism daily.
- Drawer front sits proud at the top corner. One slide has lost its alignment or a mounting screw has wallowed out. The box itself is usually fine; the slide and its screws are the failure.
- Finish lifting, blistering, or chalking on a rail or stile. Moisture has gotten under the finish at an edge, often on doors facing a dishwasher or sink. This is a finish failure, not just cosmetic, and it will spread if left alone.
- Rubbing, binding, or a gap that changes with the seasons. The cabinet box has shifted on its shims or the door has warped slightly. That shows up as a rub mark at the top or bottom corner of the door.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Homestead, a full kitchen remodel runs $14,000 to $45,000 installed, and the part-level jobs sit inside that: cabinet installation $4,000 to $13,000, countertop installation $2,000 to $6,500, backsplash $800 to $2,500, and a kitchen island $3,000 to $10,000. A small kitchen remodel lands $9,000 to $20,000. What drives the range is door and drawer count, whether you go OEM front versus aftermarket hardware, finish matching on a partial run, and whether the box needs re-shimming before new parts go on. Your quote is a flat written price with a written scope before any work starts, so parts, labor, and disposal are all in the number you sign. The work carries our written workmanship warranty, and under Clause 1 of the Haven Standard the price is written before anyone picks up a tool.
DIY or Call Us?
You can safely check a few things yourself: open the door, read the label inside the box, measure the hinge cup bore and overlay, and confirm which slide or hinge is binding. What goes wrong on a DIY swap for this kind of work is finish matching on a partial run and re-boring a hinge plate in the wrong spot, which cracks the stile and turns a $40 part into a new door. Cabinet boxes, toe kicks, and counters are heavy, and a loose upper cabinet is a genuine hazard, so we recommend stopping at measurement and letting a trained installer handle removal and re-hang. If a door or drawer is falling off, don’t keep using it; that’s how the box gets damaged. Call (844) 834-4248 and we’ll tell you what part you need and what it costs to install.
FAQs

A quality soft-close hinge or slide should give you 10 to 15 years in a normal climate, but Homestead’s humidity and the heat cycles near a range or dishwasher can cut that to 6 to 9 years. That’s the reality check most owners miss: the part isn’t defective, the environment just wears it faster. Call (844) 834-4248 for an exact quote on replacement, and estimates are free.
Sometimes. A hinge plate that’s pulled its screws can often be re-set with longer screws or a hardwood plug and reuse the original hinge, and a binding drawer can often be re-aligned without new parts. A failed soft-close damper or a cracked slide can’t be repaired, only replaced. We’ll tell you which one you’re looking at before you spend anything.
A single hinge or slide swap is a short visit, often under an hour, and a door or drawer front replacement is usually a same-visit job once the part is on hand. A partial run of several doors or a full hardware refresh runs longer and we’ll give you the timeline in the written quote. Call (844) 834-4248 and we’ll schedule a free estimate around your part.
We identify the line and bore from the label or your measurements, then source OEM for doors and fronts and quality equivalents for hinges, slides, and dampers through vetted suppliers. We also handle KraftMaid, Cambria, and Silestone when your Homestead kitchen mixes brands. You get a documented photo record of what we found and what we installed on every visit, included as standard.
If a Wellborn door, drawer, or hinge in your Homestead kitchen has failed, the fastest path to a straight answer is a phone call. We’ll confirm the part, name the installed price in writing, and schedule the visit. Call (844) 834-4248 for a free estimate.
Written by the team at Rowan Construction Group Homestead, serving Homestead and nearby areas.












